Based on the parameters of China's standard GB10085-88 worm wheel, the aluminum alloy worm gear reducer draws on the advanced technology at home and abroad, and has a unique "square box" outer structure. The box has a beautiful shape and is made of high quality aluminum alloy die-casting. Made.
The aluminum alloy speed reducer can be referred to as NMRV worm gear reducer, NMRV worm gear reducer and NMRV reducer. Its appearance is a "square box" structure that touches advanced technology. The box body is die-casted with high-quality aluminum alloy, which has the advantages of strong strength, light weight, exquisite appearance, high heat dissipation function, environmental protection and long service life. It is the selection of modern transmissions for single-machine transmission and mechatronics in the production line. It is widely used in food machinery, printing machinery, metallurgical machinery, wire and cable machinery, conveyor machinery, chemical machinery, textile machinery, printing and dyeing machinery and pharmaceutical machinery.
The functional advantages of aluminum alloy worm gear reducers are:
1. The mechanical structure is compact, compact, small and efficient;
2. The heat exchange function is good and the heat dissipation is fast;
3. Easy to install, flexible and light, superior in function, easy to maintain and repair;
4. The transmission speed ratio is large, the torque is large, and the overload capacity is high;
5. Smooth operation, low noise and durability;
6. Applicability, safety and reliability.
Note: When the operating environment is lower than 0 degrees Celsius, the following conditions must be considered
1. The motor used must be suitable for operation in low temperature environments.
2, the power of the motor must be satisfied with the large torque requirements at low temperature start.
3. If the outer casing of the aluminum alloy reducer is cast iron, it should be noted that the outer casing should become brittle and try to prevent excessive impact load.
4. When the equipment is just used, the viscosity of the lubricating oil will be higher. If there is a problem, the machine should be loaded after a few minutes of no-load operation, so as not to cause other equipment problems.
- Analysis of the cause of charging of gear reducer housing
- Repair and installation method of spiral bevel gear reducer
- Eight reasons why the gear reducer smokes
- The speed control motor has a weak work and the sound is increasing. What should we do?
- The difference between precision planetary gear reducer and geared motor
- How to lubricate the gear reducer?
- How to deal with oil leakage in gear reducer
- Precautions in daily maintenance of aluminum alloy worm gear reducer
- Common fault causes and troubleshooting methods of aluminum alloy worm gear reducer